DoorKing 1814 Uživatelský manuál stáhnout pdf (Strana 35)

3.4.5 Programming Names

In this section, names will be programmed into the system. Names are referenced to a phone

number by entering the directory code that the persons phone number has been programmed to.

1. Press

and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in

3.4.1) then press (beep).

3. Begin entering the residents name one character at a time as described on page 30.

When the desired character (letter, number or space) is displayed, press to enter

that character.

4. Repeat step 4 to enter additional characters until the desired name is displayed in the

directory. NOTE 1: 15 characters maximum. NOTE 2: If you make a mistake in steps

4 or 5, press to clear the display and start over.

5. After the last character has been entered, press (beep) to enter the complete

name. The display will be blank.

6. Repeat steps 2, 3, 4, and 5 to enter additional names.

7. Press TOGETHER to end this programming step (beeeeeep).

3.4.6 Deleting Individual Phone Numbers

This programming sequence is used to delete a single phone number under a known directory code.

Proceed to 3.4.7 to delete the resident name.

1. Press and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in

3.4.1) then press (beep).

3. Press then press (beep).

4. Repeat steps 2 and 3 to delete additional phone numbers.

5. Press TOGETHER to end this programming step (beeeeeep).

3.4.7 Delete Names

This programming sequence is used to delete a resident name from the directory. These steps will

not erase the resident telephone number from the system. Go to section 3.4.6 to delete the resident

telephone number.

1. Press and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Use the A and Z buttons to locate the name that is to be erased, then press

(beep).

3. Repeat step 2 to erase additional names.

4. Press TOGETHER to end this programming step (beeeeeep).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 56 57

Žádné komentáře

DoorKing 1814 Uživatelský manuál Strana 35